It is the easiest step if you did the previous steps as required. Use the tape measure accurately and with a lot of patience. To have an easy time handling this step, you should have the right dimensions of wood. Step 10: Attach the Wood to Allow the Boxes to Lock Together Use as many screws as you would want but remember to drill the screws in a uniform pattern. You can force the wood pieces as you square the corners with the boards. You should only attach the panel supports if you have screwed the top and sides correctly. Step 9: Attach the Panel Supports on the Back This is quite helpful if you want to have a polished and attractive look. Drill the wood deeper to make sure that the screw head won’t stick out at all. Look for an extra-large drill bit after the pilot holes are well drilled. Keep in mind that the main goal here is to have the smoothest pieces of wood. Sanding the wood multiple times ensures that it is smooth. Check if the base is at an angle of 45 degrees from the floor. Kindly do it slowly instead of slapping a large bunch at a time.Īfter that, lay the wood on an angle preferably on a slanting wall. At this point, you should be extra careful about any loose brush hairs. Paint another coat after sanding the layer back and forth. Remove brush hairs that were left after painting the first layer. As you sand, you can take a look at what you did. It is time to sand the wood again after the coat is completely dry. It is proved that the tip increases the possibility that the wet wood parts will not stick to the newspaper. It would be better if you put the wood flat on a newspaper. You must be patient at this point otherwise you will not get the best results. The best way is to paint one side at a time and let it dry completely. The layer on the brush should not be very thick as this can cause excess drip on the sides of the wood. Step 4: Paint the First Layer of Varnishīefore painting the varnish, make sure that the tin is well stirred. Don’t forget to sand the wood with the grain. To have a smooth surface, consider using 320-grade sandpaper. Using the sanding block, sand the wood carefully until it is smooth. Floating Shelf Vinyl Records Storage Things You Need Step 1: Select the Perfect Wood Size Step 2: Cut the Wood Step 3: Start Sanding the Wood Pieces Step 4: Paint the First Layer of Varnish Step 5: Sand the Wood Again Step 6: Paint Another Coat Step 7: Sand the Wood the Last Time Step 8: Put the Top and Bottom Wood Pieces above the Sides Step 9: Attach the Panel Supports on the Back Step 10: Attach the Wood to Allow the Boxes to Lock Together Step 11: Carry Your Vinyl Record Storage Tips to Make DIY Vinyl Record Storage Final Thoughts FAQs Videos How to Build a Modern DIY Vinyl Record Shelf #14. Vinyl Record Wall Mount Via Shoe Box #13. Table of Contents Homemade Vinyl Record Storage Ideas & Plans #1.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |